IEC 60898-2 PDF

by IEC This standard does not apply to circuit-breakers which incorporate residual current tripping devices, which is covered by IEC , IEC. IEC Electrical accessories – Circuit-breakers for overcurrent protection for household and similar installations – Part 2: Circuit-breakers for AC and. IEC /AMD Standard | water management, smart city, LVDC | Amendment 1 – Circuit-breakers for overcurrent protection for.

Author: Moogugul Faenos
Country: Togo
Language: English (Spanish)
Genre: Technology
Published (Last): 14 September 2005
Pages: 117
PDF File Size: 14.5 Mb
ePub File Size: 20.24 Mb
ISBN: 977-8-81868-438-6
Downloads: 80310
Price: Free* [*Free Regsitration Required]
Uploader: Mikall

The opening time shall be not less tnan 0,1 s and not more than: For this test the auxiliary switch establishing the short-circuit is not synchronized.

Reply Hello Jonas, No, your statement is not correct.

Replacement of the second ief Is this breaker fit for purpose along with Micrologic 2. You should contact the technical support of Schneider Electric in your country.

IEC | IEC Webstore | water management, smart city, LVDC

Ied your given example its not exactly as you name it: Only the English 60898- of the International Standard has been retained while adopting it as an Indian Standard, and as such the page numbers given here are not the same as in the lEC Publication. As for IECit relates to the a. But happen it does. The information under a 608988-2, befghi and 1 may be marked on the side or on the back of the device and be visible only before the device is installed.


The number of significant places retained in the rounded off value should be same as that of the specified value in this standard. Hello Jonas, No, your statement is not correct.

IEC 60898-1 and IEC 60947-2: a tale of two standards

Eic is the reason why manufacturers in addition provide a wide scope of different curves: The alternating current shall have a substantially sine-wave form and the power factor shall be between 0,85 and 0. A direct current equal to 7 In is then passed through all poles, starting from cold. The preferred values of rated voltages are given in table 1.

That is the reason why usually we meet limited number of printed technical information on CBs. Consequences can be dire if residential CBs are used instead of industrial ones.

Two-pole circuit-breakers of rated voltage V are tested in a circuit according to figure 4b. The opening time shall be not less than 0,1 s and not more than: Any remaining information not iev shall be given in the manufacturer’s literature.

Reply Dear Amey, If I understood your question well, the difference comes from ratio of nominal Icn and ultimate Icu breaking capacities ratio to service breaking capacity Ics.


The same goes for impulse withstand voltage Uimp. Or take the tripping characteristics: Kevin, You should keep it simple: What this A or A iiec. View Responses 57 Responses I am from India.

IEC /AMD | IEC Webstore | water management, smart city, LVDC

This does not preclude the free use, in the course of implementing the standard, of necessary details, such as symbols and sizes, type or grade designations. HI I would like to know what have been the design and technological trend in low and medium current and high current miniature circuit breakers. Compare those numbers to the V upper limit between phases for residential MCBs. For direct current the time constant is calibrated corresponding to the assigned time constant.

Search results for “”

Unfortunately I found no value for Icu there. The voltage on the supply side shall be measured after arc extinction and after high frequency phenomena have subsided.

Stephen, the Max Zs value is not always published in technical guides.