DEI 508D MANUAL PDF

I’d like to hook up a DEI D Field Proximity Sensor to an Arduino. This is the “manual”: Manual or automatic transmission selection. Note: In the case of D, power and ground must be hardwired to the . DEI feature error. Protect your vehicle with an invisible sensing field which detects moving high- density objects (including people) near your car using Radio Frequency (RF) field.

Author: Gardajinn Tojam
Country: Central African Republic
Language: English (Spanish)
Genre: Literature
Published (Last): 11 February 2016
Pages: 490
PDF File Size: 14.26 Mb
ePub File Size: 17.29 Mb
ISBN: 603-7-87407-216-7
Downloads: 1689
Price: Free* [*Free Regsitration Required]
Uploader: Nikonris

If both generate an output then take note of the voltages involved.

With a 10K resistor connected between the output and the 16V rail sorry, no 5V available right nowit reads 15V at the output when inactive, but drops to zero when triggered. However I’d suggest it would be best to measure. That means it’s grounding, right?

DEI Viper 508d Manual and Advice?

Is there something I can read online to get a better understanding? Hmm, rather unclear that document and my neck now aches I think it might mean the outputs are open-collector capable of mA sink.

  COLLIN DE PLANCY DICTIONNAIRE INFERNAL PDF

But I found good input to the initial problem under: Eventually I realized that the signal pins are left floating when the alarm is not triggered. I took a few electronics courses back in college, but have forgotten most of it.

DEI D Field Proximity Sensor

I’m also trying to use this sensor, but confused about what the blue and green wires do. Now I’m starting to see what the term “pull-up resistor” actually means!

If 12V you’d need a level shifting circuit such as resistor divider.

Open-collector or open-drain, same thing outputs are nice and flexible like this you can wire several of them together to one pull-up resistor to make a hard-wired AND gate too. Measure the output voltages with nothing connected, and then again with 10k resistor from output to 5V.

This is the “manual”: The blue wire is “alarm” – someone’s entered the smaller alarm perimeter. When the alarm is triggered the signal pin is connected to ground.

  LES SPERMAPHYTES PDF

DEI Viper d Manual and Advice?

This means you can connect the signal pin to a Arduino digital input pin, but you need to connect it to a pull up resistor so you get a constant value.

If mamual the latter works and gives When I first tried hooking this up to my Arduino I was worried about the sensor running on 12v. It’s a 12V circuit, it has two outputs which I’d like to sense.

I didn’t want to pass that voltage into the Arduino and fry it. MarkT Brattain Member Posts: Thanks for your help!

How would I sense that, and is it OK to connect that resistor directly to the Arduino’s 5V power even though this runs on car 12V? Without a resistor, it measures 0V when inactive, about 6. Deei, thanks so much for your help! I know thread is old. Check the PDF Manual: